The QSC PLX3602 is a lightweight rackmount stereo power amplifier, offering up 775 Watts per side at 8 Ohms, and weighing in at a mere 21 lbs. The unit is equipped with built-in subwoofer processing, filter switches, and front panel indication of bridge mono status.
The PLX3602 is a worthy and versatile solution for users who need to drive up to four loudspeakers from each amplifier channel (2 ohm loading), or who require extremely high power bridge mono operation for specific applications.
Lightweight, high-output stereo rackmount power amplifier
21-position front-panel gain controls for precise, repeatable amplifier adjustment
Cooling design with front-exit hot air exhaust, Flow-through heat sinks require no filters, eliminating clogging
Full short circuit, open circuit, thermal, infrasonic, ultrasonic, and RF protection, stable into reactive or mismatched loads
Fully selectable low frequency filtering with a choice of 30Hz or 50Hz roll-off
Front panel LED power, clip, -10 dB, and signal present indicators for system monitoring and troubleshooting, bridge and parallel mode LED indicators
100 Hz high pass and low pass filters for bi-amping subwoofer and satellite systems without the need for an external crossover
2 x XLR female, balanced 2 x 1/4" TRS phone, balanced
Output Connectors
2 x pair 5-way binding posts 2 x NL-4 Speakon
Controls Front Panel
2 x rotary Level Control knobs 1 x Power switch
Controls (Rear)
1 x Bridge/Stereo/Parallel Input Config. Switch 1 x Clip/Limiter 2 x Top 100 Hz HPF/Full/Sub 100 Hz LPF Filter switches 2 x 33 Hz HPF/Full (infrasonic) Filter switches
Indicators
2 x Ch.1,2 red Clip LEDs 2 x Ch.1,2 green -10dB LEDs 2 x Ch.1,2 green -35dB signal LEDs 1 x blue Power LED 1 x amber Parallel LED 1 x amber Bridge Mono LED
